[OmniOS-discuss] LTS r151014 installation issue from USB stick

[Guenther Alka]

I was able to install OmniOS on the new SM X11 boards when

- using a CD with the .iso
with an Sata CD drive

bios settings
- Advanced > Boot: Install Windows 7 USB support: enabled
- Boot > Boot mode: Legacy

or
you need a pci-e USB 2 card

Gea

Am 03.08.2016 um 23:00 schrieb Krzysztof Grzempa:
> Ok, i will check it tommorow...but it shame anyway that 3.0 is not 
> supported. I have no ATA port available on my motherboard so if you're 
> right im stuck..
>
> 2016-08-03 22:32 GMT+02:00 Eric Sproul <eric.sproul at circonus.com 
> <mailto:eric.sproul at circonus.com>>:
>
>     On Wed, Aug 3, 2016 at 4:18 PM, Krzysztof Grzempa
>     <grzempek at gmail.com <mailto:grzempek at gmail.com>> wrote:
>     > Ok, i used USB3 port indeed...but i also have 2 USB 2.0, so i
>     tried luck
>     > with those....the same effect... :(
>
>     I have a motherboard [1] that claims to have USB 2.0 ports but they
>     are, in fact, just USB 3.0 ports in disguise. I had to add in a real
>     USB 2.0 card to get a working console keyboard. And even then, I have
>     to switch back to the onboard ports to use the keyboard in BIOS. :(
>
>     If you can boot the machine into a Linux LiveCD or something, a look
>     at `lspci` output could answer whether you have real USB 2.0 or just
>     USB 3.0 in disguise.  The onboard USB of my board is this:
>
>     00:14.0 USB controller [0c03]: Intel Corporation Sunrise Point-H USB
>     3.0 xHCI Controller [8086:a12f] (rev 31)
>
>     Eric
>
>     [1]
>     https://www.supermicro.com/products/motherboard/Xeon/C236_C232/X11SSM-F.cfm
>
>
>
>
> _______________________________________________
> OmniOS-discuss mailing list
> OmniOS-discuss at lists.omniti.com
> http://lists.omniti.com/mailman/listinfo/omnios-discuss

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://omniosce.org/ml-archive/attachments/20160804/26f5d154/attachment.html>