[OmniOS-discuss] Zpool export while resilvering?

[Robert A. Brock]

What did you use to flash them? Fwflash just gives an error about firmware file being too large.

From: Schweiss, Chip [mailto:chip at innovates.com]
Sent: 09 June 2015 21:25
To: Robert A. Brock
Cc: omnios-discuss
Subject: Re: [OmniOS-discuss] Zpool export while resilvering?


I went through this problem a while back.  There are some gotchas in getting them back online and firmware upgraded.   The is will not talk to the drive until it has its firmware upgraded or cleared from the fault database.

This drives will not flash with multipath enabled either.

I ended up clearing the fault manager's database, disabling it and disconnecting half the SAS cables to get them flashed.

-Chip



<snip>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://omniosce.org/ml-archive/attachments/20150610/b1471b62/attachment-0001.html>